C10 Front Roll Pan Install

Remove light prep roll pan and paint per enclosed painting.

C10 front roll pan install.

The front bumper when bolted properly should provide support to keep the front frame rails from flexing side to side. There is also a yellow truck from several years back that sectioned a 90s bumper with fog lights and cut the bottoms of the front fenders off for a wrap around look. I would make a bracket from round or square tubing with angle iron welded to the ends to bolt between the. Using a drill bit drill a hole through each lower rear quarter panel and through the roll pan flange.

Only thing bad about a roll pan s is you got no protection from the front or the back to bad my friend with a 1957 cameo had to learn it the hard way he was on the free way going to a car show some kid slammed into him at 40 mph he was right behind a 1970 cuda. 1967 chevy c10 pickup 1968 chevy c10 pickup 1969 chevy c10 pickup 1970 chevy c10 pickup 1971 chevy c10 pickup 1972 chevy c10 pickup 1973 chevy c10 pickup 1974 chevy c10 pickup 1975 chevy c10 pickup 1976 chevy c10 pickup 1977 chevy c10. On 4x4 trucks and a few 2x4 trucks i have seen the rivets in the front cross member work loose or shear off. Remove roll pan and insert the license plate light and install the 8x3 4 self drilling stainless screws.

Front roll pan smooth 38 9505. The only downside is that they can be pretty tricky to install. Shop from thousands of parts and accessories to help you restore maintain and customize your chevrolet gmc dodge or ford truck or suv. 1 fiberglass some of the earliest forms of roll pans were made of fiberglass fiberglass roll pans are lightweight and durable.

To make installation easier today s fiberglass roll pan now comes with all the mounting hardware needed to install this product. A roll pan is a fascia panel that is installed on low bed trucks after the factory standard bumpers are removed. A roll pan is smooth and flat against the truck instead of protruding from the rear the way the bumper does. You have a good vision i copped out and ran a stock front roll pan.

Install and finger tighten the 8x1 stainless screws and nuts.